PerTronix D174228 Flame-Thrower Electronic Distributor Cast British A+ 4 cyl Plug and Play with Ignitor II Technology Non Vacuum Advance
Part Number: D174228
Federal and state "anti-tampering" laws regulate modifications that affect emissions from motor vehicles and prohibit the sale, installation, and on-highway use of any add-on or modified emissions-related part on any pollution-controlled vehicle unless the part has received an exemption from the California Air Resources Board ("CARB") or is considered an exempt or replacement part. If a part has a California Executive Order Exemption (aka an EO #) or meets the requirements for an exempt part such as a Cat Back Exhaust system or is considered a replacement part, it is legal for sale or use in all 50 states. We are required by law to inform you about the legality of parts that we manufacture and sell and will refuse the sale of certain parts if the following requirements are not conformed with. Use of non compliant parts for purposes other than stated can result in a citation, fines, and/or confiscation of the vehicle. For the ordered parts listed below, you must certify, by clicking one of these boxes that you are using the product in the manner stated and for the application as specified by the manufacturer.
We cannot sell this part for use on a 1975 or Newer On Highway vehicle. It will not be added to your Cart.Continue Shopping
- Additional Information
- Download Instruction Manual
- All new lightweight cast aluminum housings.
- Tailored advance curve for optimal performance and drivability.
- Integrated Ignitor II electronic ignition with variable dwell maintains peak energy throughout the entire RPM range, reducing misfires while improving engine performance.
- Develops on average 4 times more available energy between 3000 and 5000 RPM, and 2 times more available plug voltage.
- Peak current level is reached just prior to spark for maximum energy without the heat build-up, increasing coil and module life.
Performance Distributors for British Engines Flame-Thrower HP distributors take the performance line of distributors one step higher. That's right, HP stands for High Performance, and that's what you get with our all new HP distributors. These distributors feature patented Ignitor II technology and are available with top exit or our new side exit caps. For optimal performance, use our Flame-Thrower II 45,000 volt coils. FEATURES • All new lightweight cast aluminum housings. • Tailored advance curve for optimal performance and drivability. • Integrated Ignitor II electronic ignition with variable dwell maintains peak energy throughout the entire RPM range, reducing misfires while improving engine performance. • Develops on average 4 times more available energy between 3000 and 5000 RPM, and 2 times more available plug voltage. • Peak current level is reached just prior to spark for maximum energy without the heat build-up, increasing coil and module life. • Adjusts spark timing at higher RPMs to compensate for the inherent electronic delay. • Senses startup and develops more energy for quicker, easier starting. • Built in reverse polarity and over current protection shuts down the system, preventing component damage. • High dielectric strength cap with brass terminals. • Top or side exit caps available. • Balanced rotor with overmolded brass contact. • Warranty: 30 months electronics / limited 1 year mechanical. • Not legal for sale or use on pollution controlled motor vehicles.
Download Instruction Manual
Emissions CodePerTronix Performance Ignition and Exhaust Brands use a voluntary product identification program whereby all emission sensitive products can be identified by placing numbered labels in product packaging and listing corresponding numeric codes next to each part number. The corresponding numbers and explanations are as follows:
This Product has been granted a California Air Resources Board (C.A.R.B.) Executive Order ("EO") Exemption, or is considered a Direct Replacement or Consolidated Replacement part. It is 50 State Legal when installed on the appropriate vehicle per the Manufacturer Application guide and Installation Instructions.
This product is Legal for use on 1974 and older non catalyst equipped vehicles and is considered a Replacement Part per California Air Resources Board regulations, as long as ALL emissions sensitive components are retained, including A.I.R., EGR, Heat Risers etc. Failure to retain any of these components, or use on any 1975 or newer catalytic converter equipped car would render this product Illegal for Street or Off Highway use in California, or in states that have adopted California Emissions regulations and may only be used for Closed Course Competition.
This product is Not legal for Street or Off Highway use in California or in states that have adopted California Emissions Regulations and is only intended for Closed Course Competition use, except 1965 and older US manufactured California Certified vehicles, 1967 or older US manufactured Federally Certified vehicles, or 1967 and older Foreign manufactured vehicles which may have any aftermarket add-on or modified part installed as long as the vehicle can still meet the tailpipe emissions standards for the year of the vehicle and retain any original or retrofit crankcase control (PCV) devices and NOx device required for the year of the vehicle.